Fujifilm X-E5 Kit with XF 23mm f2.8: Street Setup

Quick answer

Set up your Fujifilm X-E5 with the XF 23mm f2.8 by configuring back-button focus, zone autofocus, and a manual exposure preset so you can shoot fast without looking at the screen.

Street photography setup steps

1. Set back-button AF: In the button/dial setting menu, assign AF-ON to a rear button (e.g., the AE-L button). Disable shutter half-press AF. This lets you focus separately from releasing the shutter. Common mistake: forgetting to re-enable half-press AF when handing the camera to someone else.
2. Choose zone AF and small focus area: Set AF mode to Zone and select the smallest zone size. Position it in the upper-center of the frame. This gives you a fast lock-on without hunting across the whole scene. If your subject is off-center, quickly tap the focus point with your thumb on the touchscreen rather than moving the zone with the D-pad.
3. Dial in manual exposure preset: Set shutter speed to 1/250s, aperture to f/5.6–f/8, and auto ISO with a minimum shutter of 1/250s and max ISO 6400. This keeps motion blur low and depth of field wide enough for zone focusing. In very low light, drop shutter speed to 1/125s and open aperture to f/2.8, but watch for missed focus on moving subjects.
4. Use the tilting screen at waist level: Flip the screen up 90 degrees and shoot from the hip. This makes you less conspicuous and lets you capture candid moments without raising the camera to your eye. Check that the screen is clean and bright enough to see in sunlight; increase brightness in the display settings if needed.
5. Review and adjust on the fly: After a few frames, review the histogram and exposure compensation. If highlights are clipped, dial in –1/3 or –2/3 EV. If shadows are too dark, add +1/3 EV. Don't chimp after every shot – review every 5–10 frames to stay in the flow.

Product facts

• Fujifilm X-E5 Gehäuse Schwarz + XF 23mm f2,8 R WR: 40.2 megapixel X-Trans CMOS 5 HR sensor and X-Processor 5. High resolution lets you crop street shots aggressively, but you'll want to keep shutter speeds above 1/125s to avoid blur from camera shake.